![]() |
#1
|
|||
|
|||
![]()
Hello, just found out that the level sensor 2 pin connector is missing from the used HSF4 kit i bought, can anyone point me where i can source the 2 pin connector that is currently on the kit?? otherwise i will repair with a standard connector it but will have to cut and change the level sensor cable end as well.
IMG_0851.JPG By the way, i'll be installing in a 996 IMG_0850.JPG |
#2
|
|||
|
|||
![]()
The connector is made by tyco or amp. You can use any pair of mating connectors for this
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
![]()
Hey Richard! thanks for the Info.. i ended up using a Molex Male / Female connector plus added a little bit more or cable. Continuity checked on all cables and everything in good shape now!
some pics IMG_0853.JPG IMG_0854.JPG |
#4
|
|||
|
|||
![]()
Thank for the update... All good.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
![]()
Richard, can you tell me the dimensions of all the orings used in the system? Also the one that goes on the right angle fitting as well!
Last edited by Gclasse; 09-06-2017 at 03:48 AM. |
#6
|
|||
|
|||
![]()
I don't know the size of the o-ring on the right-angle fitting as we don't make them.
There are many o-rings on the system , be a bit more specific.
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
![]()
Don't worry Richard, Jeff (Howerton engineering) sent me some spare orings on different sizes. All good now!
|
#8
|
|||
|
|||
![]()
Richard, on my setup (porsche), i decided to install the nozzles at both intercoolers sides. Therefore, I placed the FAV close to driver side intercooler and from there I ran the 4mm tubing to a check valve which was then distributed to each intercooler. Refer to pictures included.
On your experience, Is there a concern with the total length of the 4mm used on this setup? Last edited by Gclasse; 13-06-2017 at 04:19 AM. |
#9
|
|||
|
|||
![]()
I suggest putting an inline checkvalve near the far-away jet to stop water siphoning after lift off.
__________________
Richard L aquamist technical support |
#10
|
|||
|
|||
![]()
Got it, ordered one from your website today! thanks
|
![]() |
|
|