#1
|
|||
|
|||
Flammability of Methanol/Water Mixtures
Hello to Everyone,
I am new to the use of water injection in my car. I was a bit concerned about mixing methanol and water as I read in an industrial brochure that a 33%methanol to 67% water mixture by volume is the absolute maximum mixture to keep it non-flammable. Is a 50%methanol/water mix flammable? Even if it is stored in a plastic washer container in the engine bay, I'dlike to play it safe. Thanks! |
#2
|
|||
|
|||
Flamability
My kitchen chemistry experiance is the same -1/3 -2/3 H2O I cold not get to light.
The typical 1/2 - 1/2 does light but does not burn very well. |
#3
|
|||
|
|||
In my experience the 'methanol' effect tails off after just 20%, let alone 33% meth/water.
So I don't see much point going beyond 30% anyway. In practice I've settled down to 15-20% and it works well. :smile: |
#4
|
|||
|
|||
Thanks for the replies. I'll stick with the 25% meth to water ratio. I was just curious why a lot of references are around with regards to the 50/50 mix
|
|
|