#1
|
|||
|
|||
LED wiring for WI activation
Hi
I have lost my wiring diagram and need to install a LED to show me the WI is activated. I know the LED goes accross the pressure switch. But what is the naode and the cathode?!!! Which one goes to the long leg and which to the shrot leg of the LED?!!! Cheers
__________________
Ultimate-Racing |
#2
|
|||
|
|||
Re: LED wiring for WI activation
Quote:
For 2d, long leg to the blue and short leg to the black wire of the manifold pressure switch.
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
HI
Thanks for the reply. 1s is infactwhat I have. Cheers
__________________
Ultimate-Racing |
#4
|
|||
|
|||
Richard, is there a way of connecting up an LED to show when the WI is active when using the 2c with MF2?
I'm using a MAP sensor rather than a pressure switch. |
#5
|
|||
|
|||
Quote:
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
Quote:
I know LEDs draw VERY little power, and shouldn't hinder the HSV signal much at all, but I just wanted to check with the boss before I changed the LED wiring on my setup. Also, having the LED pulse with the HSV will make for a cool little disco show in the car! :lol: |
#7
|
|||
|
|||
Quote:
__________________
Richard L aquamist technical support |
#8
|
|||
|
|||
Excellent, thanks Richard.
While you're around, you couldn't pass comment on my thread in 'avoiding distaster' could you? http://www.aquamist.co.uk/phpBB2/vie...hp?p=9199#9199 |
|
|