![]() |
#11
|
|||
|
|||
![]()
No but have friend who can or can use local company.
Is it the flow sensor table not being linked causing the issue? |
#12
|
|||
|
|||
![]()
Yes, the flow table must match the jet number. Until you have done the soldering, you can not set the faulsafe (SC, WL and WH) properly.
__________________
Richard L aquamist technical support |
#13
|
|||
|
|||
![]()
Ah!!!! My garage fitting hasnt done it correctly then!
Will get on the case!! Should i also solder the pre amp to 2.5 ? |
#14
|
|||
|
|||
![]()
Why don't you send the controller back to me and I will get it done within the same day. I can also do some calibration for you on the 0.6mm jet.
Richard
__________________
Richard L aquamist technical support |
#15
|
|||
|
|||
![]()
Yeh that would be brilliant Richard thank you so much.
Just send the actual board to you yes, nothing else? Cheers |
#16
|
|||
|
|||
![]()
just the board with the box for protection.
__________________
Richard L aquamist technical support |
#17
|
|||
|
|||
![]()
no worries, all padded up and in padded envelope to be send tomorrow morning recorded delivery signed for.
will you be in office on Tuesday morning or shall send to home address? PM me if home address is better. cheers |
#18
|
|||
|
|||
![]()
I will be in the office on Monday and Tuesday this week.
ERL Ltd Iroko house Bolney Ave Peacehaven East Sussex BN10 8HF
__________________
Richard L aquamist technical support |
#19
|
|||
|
|||
![]()
Perfect, will be with u by 1pm on Tuesday.
|
#20
|
|||
|
|||
![]()
Write your return address inside.
__________________
Richard L aquamist technical support |
![]() |
|
|