#11
|
|||
|
|||
Re: Mazdaspeed 6 (update) SN #12091 onwards
You can certainly run HFS-2 on your car, injection is based on IDC only or 70% IDC/30% manifold pressure.
You need a 1/8NPT tap and a few drop of loctite for the nozzle adaptor.
__________________
Richard L aquamist technical support |
#12
|
|||
|
|||
Re: Mazdaspeed 6 (update) SN #12091 onwards
OK,
What will be the best way to order; if I can get a link for best results. Thanks, Richard |
#13
|
|||
|
|||
Re: Mazdaspeed 6 (update) SN #12091 onwards
Please check your pm.
Richard
__________________
Richard L aquamist technical support |
#14
|
|||
|
|||
Re: Mazdaspeed 6 (update) SN #12091 onwards
Yes, you can. Make sure it is a HFS2-v2. Ity can be upgraded later.
__________________
Richard L aquamist technical support |
#15
|
|||
|
|||
Re: Mazdaspeed 6 (update) SN #12091 onwards
The v2 wiring diagram has been updated to v3.
13th May 2012
__________________
Richard L aquamist technical support |
#16
|
|||
|
|||
Re: Mazdaspeed 6 (update) SN #12091 onwards
The v3 wiring diagram has been updated to v4.
8th July 2012
__________________
Richard L aquamist technical support |
#17
|
|||
|
|||
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
Hi Richard,
I recently bought HFS4. Electric men installed me as WIRING DIAGRAM MS6 v4. And then my boost stay lower than it was. And I understood that my boost control brains of HFS4. Set jets which was included 0.7 mm. when we are working on 100% IDC + gain MAX then red LED turns around 4000 rpm. and the boost is reduced to 0.8 bar it means that jets too small for my configuration. but when I turn on the 100% boost then red LED does not light up. But still, my car is going slower than before the installation HFS4. HFS4 brains cut off boost by themselves . WHY??? tell me which way to IDC, or boost? I bought this WMI HFS due just this working by IDC. power of the car before installation was 320 hp now its about 270-300hp. my modes: FMIC, CAI, full exhaust 3'' + versatuner I plan to get 350 hp thanks |
#18
|
|||
|
|||
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
What water/methanol mix are you running?
__________________
Richard L aquamist technical support |
#19
|
|||
|
|||
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
|
#20
|
|||
|
|||
Re: Mazdaspeed 6 (update: 8th July 2012 ) SN #12091 onwards
Hi Richard do you remember my questions?
please... i need your help Last edited by Presss; 09-06-2013 at 02:49 PM. |
|
|