#11
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Ok, thanks Richard, tomorrow I will test it
|
#12
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Runs perfect on the test!!
|
#13
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Thank you for the feedback
__________________
Richard L aquamist technical support |
#14
|
|||
|
|||
Re: AUDI specific wiring diagrams...
is it possible to wire the aquamist HFS3 to audi RS6 2009 ???
|
#15
|
|||
|
|||
Re: AUDI specific wiring diagrams...
I will check, I am sure it can.
__________________
Richard L aquamist technical support |
#16
|
|||
|
|||
Re: AUDI specific wiring diagrams...
I will be thankfully if you make sure
Special thanks sir |
#17
|
|||
|
|||
Re: AUDI specific wiring diagrams...
Do you have a wiring diagram for Audi RS6 V8 biturbo BCY 2003-2005 ?
__________________
Audi S8 with RS6 engine = RS8 |
#18
|
|||
|
|||
Re: AUDI specific wiring diagrams... 2.7T
W0w been a while, but I'm going back over my wiring and wanting some clarification. Diagrams for the 2.7T Audi's have a white and orange wire to the N75, but in actuality it's white and brown from the HFS-3. Also the diagram shows the Blue wire to the MPS/MAP Sensor, but the documentation shows us using the orange wire. "http://www.aquamist.co.uk/HFS3/manual/HFS3-v3.0w.pdf" Page 18 So there is some confusion (again since it's been a while since I hooked all this up and just trying to validate everything since I'm getting a n75 short to ground for some reason. I think as of right now there is a yellow, orange, black wire out of the ECU RJ45 connector that are not being used. I'm very hopeful that Richard is still up and kicking!! Thanks Tory |
#19
|
|||
|
|||
Re: AUDI specific wiring diagrams...
The N75 wire should be brown and white, not orange.
__________________
Richard L aquamist technical support |
#20
|
|||
|
|||
Re: AUDI specific wiring diagrams...
So happy to see you around Richard. Thanks.. Can you also answer me where this miracle brown wire is? I have it wired but I don't see it in the RJ45 Jack, it's in the loom for sure and wired to my N75 but looking at the RJ45 I don't see the brown wire, is it somewhere wired together with something else inside the loom?
And then regarding the use of blue wire inside the diagram but the aquamist docs show the orange? (this darn Orange wire,nothing but trouble ) Thanks Tory |
|
|