#31
|
|||
|
|||
Re: Mazdaspeed 3
Quote:
I like you to do some test for me: 1. Put the DHB jumper to DFS for the time being to disable the failsafe. 2. Move the PRK jumper to FDC. This shows the fuel flow. Tell me how many bar you see on the gauge at wot. Just a matter of interest, could you not get any support from your supplier?
__________________
Richard L aquamist technical support |
#32
|
|||
|
|||
Re: Mazdaspeed 3
Did what you asked and 7 bars popped up on gauge at wot, no feedback from supplier cause they have never installed Aquamist before
|
#33
|
|||
|
|||
Re: Mazdaspeed 3
Thank you.
1. Your fuel idc is maxed out around 70-75%. Now reinstate the jumper back to PRK. 2. DFS back to DHB to reinstate the failsafe. Next steps: 3. Set the THRES to 10am 4. Set the "GAIN" trimmer to 1pm to match the f-idc for the aquamist. Questions: 5. Tell me how many bars on the gauge this time. So far so good
__________________
Richard L aquamist technical support |
#34
|
|||
|
|||
Re: Mazdaspeed 3
ok sounds good I'll get back to ya
Last edited by jdraps13; 08-05-2015 at 12:47 PM. Reason: Fucked up |
#35
|
|||
|
|||
Re: Mazdaspeed 3
Quote:
|
#36
|
|||
|
|||
Re: Mazdaspeed 3
Now set your WL to 10am and WH at 2pm, does the failsafe trigger ttis time?
__________________
Richard L aquamist technical support |
#37
|
|||
|
|||
Re: Mazdaspeed 3
No failsafe triggered
|
#38
|
|||
|
|||
Re: Mazdaspeed 3
And my spray seems to be sorta tic, anytime Idc is over 9 in spraying, slow accelerations cruising on highway? Wierd
|
#39
|
|||
|
|||
Re: Mazdaspeed 3
What is the serial number of your controller?
__________________
Richard L aquamist technical support |
#40
|
|||
|
|||
Re: Mazdaspeed 3
Serial number is #121688
It's like it doesn't like my idc, sprays all the time pretty much even low throttle blimps and cruising, should I try running it boost based? |
|
|