#51
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
Looks like it is working now?
__________________
Richard L aquamist technical support |
#52
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
work!!!
I made a few data log THRES: 11.00 AN6 pink= 0V-0% 5V-100% (Flow sensor signal: 0.5 to 4.5V) THRES: 10.00 failsafe activated BKSW green= boost on/off |
#53
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
I add some upgrades
|
#54
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
Amazing soldering work. You now have all the options.
I notice an over shoot on the flow signal. If you can shorten the line between FAV and jet, you can minimise this effect. What jets are you running?
__________________
Richard L aquamist technical support |
#55
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
final setting
THRES: 11.00 GAIN: 12.00 default FS-DL: 12.00 default WL: 10.00 SC: 13.00 WH: 14.00 Jet size: 0.4/0.6 0.9mm restrictor ................... 0 - 1080cc/min Jumper link: default HFS-4 flow sensor map: solder link 1-2 IDC pre-amplifier gain: x2.5 Last edited by sniper; 19-11-2015 at 06:35 AM. |
#56
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
Is this system setting working well for you. If you would like a greater linearity you can request a "lower" flow valve or go for a smaller restrictor.
__________________
Richard L aquamist technical support |
#57
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
Richard
All jet are tied to the parameters detonation If I have a detonation, my changes are as follows: jet 0.6 / 0.6 (0.8) 0.9mm restrictor delete Currently Is this system (Jet size: 0.4/0.6) working good |
#58
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
Quote:
I'm having same failsafe issue again after changing injectors 840cc to 1080cc. Adjusted threshold from 12 a clock to 10 since IDC dropped but no effect. Still don't see leds in the paragraph display. How/what do I need to adjust to get this to spray again? |
#59
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
What is your maximum duty cycle on the new injectors?
You may need to use x1.5 instead of the x1 is you are not using full duty cycle.
__________________
Richard L aquamist technical support |
#60
|
|||
|
|||
Re: HFS-3 not spraying ::mystery solved::
Need to check the max duty but I believe it is below 60% at this point it tuning. What do you mean x1 to 1.5x? I remember reading something about scaling in some other thread but can't find it in the manual.
In the meantime; I'll be using pump fuel and E85 so my duty will be varying a lot depending which tune I'm running so was thinking of changing to MAP sensor control. I have the blue wire from the gray harness connected to oem MAP signal but my circuit board looks like this MPS/IDC? https://www.dropbox.com/s/9jy271vhgk..._0447.JPG?dl=0 |
|
|