Water Injection Newbie ?'s

kickstand · #1 02-09-2005, 07:40 PM

I read the stickys and I understand the concept of how to tune it...Kind of. My questions is more based on Electromotive TEC3. I have my aquamist hooked up through there on GPO 1 so it is used on percentage based. I was wondering if someone could help me out with an example of how to setup the 16X16 table that controls the water injection. My current setup is 2.0L DOHC 8.6:1 compressions forged innerds. Precision Turbo SC51 turbo intercooled 57 lb injectors. Looking for about 400 whp on pump gas hopefully. Going to be injecting water methanol mix. If anyone could help or point me in the right direction it would be great.

Richard L · #2 08-09-2005, 06:11 PM

Try setting up a water to fuel ratio of 10%.

kickstand · #3 10-09-2005, 09:58 PM

Ok ill try that thanks a lot