Ecoboost Mustang

msp1609 · #1 19-05-2016, 02:35 AM

Is there any possibility of getting a wiring diagram for a Ecoboost Mustang using a HFS-3. I have a kit that is currently setup for a mazdaspeed 3 ecu is there any re soldering of the board required?

Thanks

Richard L · #2 19-05-2016, 07:12 AM

I do not have a factory wiring diagram for the engine. If you can send me one, I will make a drawing for you.

I believe the engine is 2.3L turboed and direct injection?

msp1609 · #3 19-05-2016, 11:32 AM

Richard,

Yes it is also a 2.3L direct injection motor. The mustang 2.3 is actually based on the 2.3 in the mazdaspeed. I am working on getting a pin out for it.

msp1609 · #4 20-05-2016, 02:08 PM

Richard,

I believe this is what you need. I was able to find all the sensors in the mazdaspeed diagram. I had to upload it to my personal ftp as I couldn't attach it to the site.

https://onedrive.live.com/redir?resi...int=file%2cpdf

Thanks!

Richard L · #5 21-05-2016, 09:28 AM

This is great.

In order to make a proper drawing, I also the outline of the ECM, can you help? A clear photo will also work.

Richard L · #6 21-05-2016, 10:07 AM

This one close?

msp1609 · #7 22-05-2016, 12:46 AM

From the photo's i've looked at this is what i came up with.

EDIT: Just went and popped my own ecu connector off and can verify that it is the connector in the photo i attached

Richard L · #8 22-05-2016, 09:23 AM

Looked like the ECU of the ecoboost of the Focus st is not the same. Can you tell me where pin #1 is?

msp1609 · #9 22-05-2016, 01:18 PM

Rich i've marked both pin #1's in this photo. Had to zoom in on the photo to read the stamping

Richard L · #10 22-05-2016, 05:49 PM

Thank you for the update. I should be able to make the drawing an post it here in the next few days.