Mazdaspeed 3

[Richard L]

If you have the kit already, go to page 21 of the user manual. If you have lost the used manual, you can download it from here. Version 3.

[yokimazoku]

im wondering what year mazdaspeed this diagram is for. I have a 2007 and im looking at the ecu connector pinout and it seems slightly different. The #1 fuel injector coil - on the sheet im looking at says its 2BA not 2BB. Is there any way to verify this?

[yokimazoku]

Nevermind that example is correct ignore that post.

[jdraps13]

So on number 6 cut the connection to the negative?

[Richard L]

Originally Posted by jdraps13

So on number 6 cut the connection to the negative?

"6" Connection is for alter map sensor ranges.
Not sure what you meant by negative.

[Richard L]

I think I know what you are after....

Yes, you can follow the diagram exactly.

[jdraps13]

on page 21, 1-6 is for customizing the board, #6 is pwm and it is connected to the negative,
for my 3 port ebcs is that the one i cut

[Richard L]

Now I am really confused.

Can you tell me exact what you want the system to do for you. You referred to a old post on BCV, not MPS sensor range.

Start again.

[jdraps13]

Hey Richard having troubles setting up my failsafe, seems to be spraying with next to no load, my sc is set at 6 bars I think wh is set properly but can't figure out how to set WL proper, how might I delay spray

[Richard L]

Originally Posted by jdraps13

Hey Richard having troubles setting up my failsafe, seems to be spraying with next to no load, my sc is set at 6 bars I think wh is set properly but can't figure out how to set WL proper, how might I delay spray

What is the position of the "THRES" on the controller?