FAV not working from controller

[boostsys]

Hi, I need help.
Recently I have installed new Aquamist HFS-3 kit to Subaru Sti and started system testing according to manual. But testing the spray pattern of the jets have failed, FAV doesn't work.
Test "Priming and purging of the system" is ok.
Harnesses are switched correctly.
At the gray harness green wire switched to injector "-", red wire switched to injector "+".
When I put 12V across the two parallel prongs of FAV coil it works.

[Richard L]

Can you post a picture of the controller, a nice hi-res, in focus picture. I like to see the programming pin on the right hand side of the board.

[boostsys]

Now I have only this photo.

[Richard L]

When you tested the system, what jumper did you use to link the SYS?

[boostsys]

I used PRK jumper to SYS

[Richard L]

The jumper link remained on the FAV?

[boostsys]

Originally Posted by Richard L

The jumper link remained on the FAV?

Yes, jumper link remained on the FAV

[Richard L]

Good.

Do you have a digital voltmeter?

[boostsys]

Originally Posted by Richard L

Good.

Do you have a digital voltmeter?

Yes, I have multimeter.

[Richard L]

Great. Can you unplug the red harness and measure the resistance of the two outer pins (red and black).