#11
|
|||
|
|||
Re: FAV not working from controller
I can do this tomorrow.
|
#12
|
|||
|
|||
Re: FAV not working from controller
Resistance between red and black pins - 0 Ohm.
Last edited by boostsys; 02-03-2016 at 07:19 PM. |
#13
|
|||
|
|||
Re: FAV not working from controller
This with the FAV plugged in?
__________________
Richard L aquamist technical support |
#14
|
|||
|
|||
Re: FAV not working from controller
|
#15
|
|||
|
|||
Re: FAV not working from controller
0 ohm is a short circuit. The FAV should have a resistance of 12 ohms. What resistance scale were you on?
Send a picture of the reading.
__________________
Richard L aquamist technical support |
#16
|
|||
|
|||
Re: FAV not working from controller
Oh, sorry. There is no resistance between red and black pins.
|
#17
|
|||
|
|||
Re: FAV not working from controller
OK.
Measure the resistance between black and blue Also can you check the inside of the FAV connector. I there must be a loose joint inside.
__________________
Richard L aquamist technical support |
#18
|
|||
|
|||
Re: FAV not working from controller
Inside of the FAV connector red and yellow, black and blue wires soldered together
|
#19
|
|||
|
|||
Re: FAV not working from controller
Are they soldered onto the the two connector's contacts securely?
__________________
Richard L aquamist technical support |
#20
|
|||
|
|||
Re: FAV not working from controller
I will have checked it tomorrow.
Maybe red wire have a problem, because between yellow and black (blue) resistance 13.5 Ohms. |
|
|