#1
|
|||
|
|||
Mazda RX7 FD3S Series 8 Setup
Hi Guys,
Does anybody have a wiring diagram for a series 8 rx7. I have seen diagrams for the earlier 8 bit ecus but not the 16 bit. Also what should be the setting for on-board trimmers and advanced system configurations. My engine spec is: stock port 13B-REW, GT35R Single Turbo, 1680cc secondary injectors, 550cc primary injectors, OEM map sensor and apexi pfc ecu. I plan to run preturbo and .6 at the boost elbow. Thanks. |
#2
|
|||
|
|||
Re: Mazda RX7 FD3S Series 8 Setup
I found this might be the right one?
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: Mazda RX7 FD3S Series 8 Setup
thats the one. Do you have the pins for the last right connector?
|
#4
|
|||
|
|||
Re: Mazda RX7 FD3S Series 8 Setup
Re-pasted. Sorry. see above
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
Re: Mazda RX7 FD3S Series 8 Setup
|
#6
|
|||
|
|||
Re: Mazda RX7 FD3S Series 8 Setup
All wires must go to the appropriate pins on the 16-bit ECU.
__________________
Richard L aquamist technical support |
Tags |
fd3s, rx7 |
|
|