Nozzle size

[SAMzG35]

Thanks
One more questions
The flow chart in the HFS6 manual does not match the flow chart on the website and in the newer manuals (HFS3/4). Total of three different versions.

The one in the HFS6 manual says at 120psi a 0.7mm jet flows at approximately 355~360cc
The one in the HFS3/4 manual says at 120psi a 0.7mm jet flows at approximately 245-250cc
The one on the website says at 120psi a 0.7mm jet flows at approximately 310~315cc

Which one would be correct?

[dlheman]

Originally Posted by SAMzG35

Thanks
One more questions
The flow chart in the HFS6 manual does not match the flow chart on the website and in the newer manuals (HFS3/4). Total of three different versions.

The one in the HFS6 manual says at 120psi a 0.7mm jet flows at approximately 355~360cc
The one in the HFS3/4 manual says at 120psi a 0.7mm jet flows at approximately 245-250cc
The one on the website says at 120psi a 0.7mm jet flows at approximately 310~315cc

Which one would be correct?

The flow table / chart is just a guideline, but i found it to be accurate enough on my HFS3 and HFS4. Maybe there is a change between HFS6 and HFS3/4. The best way to do this is to do an actual 60 seconds spray of the selected jet using the SYS jumper.

And remember, the more jets used the more loss of pressure = the lesser each jet will flow out.