#31
|
|||
|
|||
Re: New HFS-1 system not working
I think the best way to achieve what you want is what Richard proposed above. Use the system to trigger at a boost setting above the wastegate pressure. This way if you get a failsafe the system stops injecting.
On the other hand, when the system is setup properly, if the "B" light goes off dumping boost, the system is not spraying properly. |
#32
|
|||
|
|||
Re: New HFS-1 system not working
Quote:
As a side note, and please don't take this personally I believe a lot of confusion comes from the way the installation/owners manuals are written. Since its written in British english its a bit different at explaining things then what we are accustomed to here in the US. I believe if an outside source was to write the manual everyone would be better off. Thanks for all your help! Last edited by blk01s4; 08-01-2011 at 05:51 PM. |
#33
|
|||
|
|||
Re: New HFS-1 system not working
Quote:
Thanks yea I mentioned that above, if the system is setup right B will always stay on. |
#34
|
|||
|
|||
Re: New HFS-1 system not working
Always set the bargraph to about 5 bar at full flow, so it won't trigger the "overflow" (WH). I will look into a more user friendly style of writing manual. I read it through, it is quite discontinued, doesn't make good reading.
__________________
Richard L aquamist technical support |
|
|