|
#1
|
|||
|
|||
Re: Water Level light
In this case of both led activates, it indicate a failsafe trigger, nothing to do with the water level sensor.
- "Low tank level" led on = water fluid level - "Water injection" + "water level" led on = failsafe trigger - Both led off = normal Which one of the above statements is not true?
__________________
Richard L aquamist technical support |
#2
|
|||
|
|||
Re: Water Level light
Quote:
If the failsafes are set properly only the water level light comes on under any instance when the threshold has been meet or exceeded If they WL is set wrong to simulate no flow or the blue harness is unplugged so the pump doesn't run then both lights come on |
#3
|
|||
|
|||
Re: Water Level light
Quote:
Normally, the "water injection led" does not come on. "B" light comes on when the threshold is reached. Does this make sense?
__________________
Richard L aquamist technical support |
#4
|
|||
|
|||
Re: Water Level light
Quote:
The only difference that happens now is the water level light comes on with any injection and the water injection never comes on but it does trip the failsafe relay to cut boost. If the aquamist was seeing a condition where it was out of water or the level sensor was faulted and grounded would the water level light stay on solid or flash |
|
|