#1
|
|||
|
|||
FAV not working from controller
Hi, I need help.
Recently I have installed new Aquamist HFS-3 kit to Subaru Sti and started system testing according to manual. But testing the spray pattern of the jets have failed, FAV doesn't work. Test "Priming and purging of the system" is ok. Harnesses are switched correctly. At the gray harness green wire switched to injector "-", red wire switched to injector "+". When I put 12V across the two parallel prongs of FAV coil it works. |
#2
|
|||
|
|||
Re: FAV not working from controller
Can you post a picture of the controller, a nice hi-res, in focus picture. I like to see the programming pin on the right hand side of the board.
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: FAV not working from controller
Now I have only this photo.
|
#4
|
|||
|
|||
Re: FAV not working from controller
When you tested the system, what jumper did you use to link the SYS?
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
Re: FAV not working from controller
I used PRK jumper to SYS
|
#6
|
|||
|
|||
Re: FAV not working from controller
The jumper link remained on the FAV?
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
Re: FAV not working from controller
Yes, jumper link remained on the FAV
|
#8
|
|||
|
|||
Re: FAV not working from controller
Good.
Do you have a digital voltmeter?
__________________
Richard L aquamist technical support |
#9
|
|||
|
|||
Re: FAV not working from controller
Yes, I have multimeter.
|
#10
|
|||
|
|||
Re: FAV not working from controller
Great. Can you unplug the red harness and measure the resistance of the two outer pins (red and black).
__________________
Richard L aquamist technical support |
|
|