#1
|
|||
|
|||
HFS3 V2KC default pcb setting
Hello,
I just got hand on a HFS3 V2KC board which was installed on a Mitsu L200 turbo diesel. This PCB has gone thru few changes. I would like to set it up back to factory setting (it is going on an evo3 now) anyone would have a picture of same PCB with default setting ? Or could you tell me what are the default settings ? I'm pretty sure the MPS soldering has to be removed, then solder bridge IDC again (I think this has been cut) now what about CUST, PWM-, PWM+ Then *1, *1.5, *2 thanks Last edited by zakshaker; 09-06-2017 at 06:10 PM. |
Thread Tools | |
Display Modes | |
|
|