#101
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Hey guys
Quick Q about wiring in the HFS-3 to an EVO 7 JDM ECU. In the Diagram it shows a red, green and a pink wire to go in to the ECU harness. However the RJ-45 cable supplied does not have a pink wire which one am I supposed to connect to pin 42 for the +alt map switch. |
#102
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
^^^I think the orangy looking wire is the pink one....
I am installing my hfs3 in my evo8 atm and having some problems with getting the pump to prime...did it work well for you? |
#103
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Quote:
Our apology.
__________________
Richard L aquamist technical support |
#104
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Richard :
lol, no apology needed the amount of help you provide is above and beyond and I am sure everyone appreciates it. daymean : Sorry mate, I have not tried to turn the system on yet as my engine is still not in the car. When its back in I will let you know Also I will have lots of pics of the install. |
#105
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
X2 both Richard and Jeff @ Howerton.
|
#106
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
hey guys, back to bother you again
I finished the wiring for the control units power and I can only get the one LED to light up. Is this because I have not filled the tanks for the first time yet ? I am still putting the motor back in but all the sensors and wiring is done. I read the manual and saw it should come on after 5-10 secs ? what am I missing
__________________
ಠ_ಠ 2001 EVOLUTION VII - 2.4L + AQUAMIST
|
#107
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Disconnect the water level sensor and try again.
The system will not start up if the tank is empty.
__________________
Richard L aquamist technical support |
#108
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
problem solved. thank you muchly
__________________
ಠ_ಠ 2001 EVOLUTION VII - 2.4L + AQUAMIST
|
#109
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Hey Richard,
When setting up the Sensor calibration, should this be done with the jumpers in test mode, while the car is stationary? |
#110
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
It has to be done on the road to be certain.
I suggest 10 clicks on WL and WH from ZERO. Set the SC to 12 o'clock Let me knwo how many bar you are seeing with this setting. Where are you located Richard
__________________
Richard L aquamist technical support |
|
|