#1
|
|||
|
|||
wI on a TD5 Landrover ...still
evening gentle folk.
I am putting a 1S system on my TD5 landrover and am at the final stages of completion, I do however have one question about wiring. I have a 806-288 race loom which I am condining with a DDS 3 V8 in car gauge. I notice that the DDS interface has a pair of contacts for a level switch whic I have fittedto the washer tank as a fail safe however the loom also has a pair of thin black wires with a connector on it which could in the absence of a DDS3 module be used on a float switch as a pump cut off. As I have a DDS3 what do I do with these wires as they are part of the race loom??? all posts gratefully received :roll: :lol: |
#2
|
|||
|
|||
If you have DDS3 gauge, you should have a separate water level sensor. The sensors should be wired and installed independently.
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
cheers richard
so the DDS water level sensor can over ride the loom float switch sensor...cool. I guess I can just cut back and terminate. thanks :lol: |
|
|