waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and new products > Aquamist HFS-6 forum

Reply
 
Thread Tools Display Modes
  #1  
Old 05-08-2015, 03:18 PM
Aleibcas Aleibcas is offline
Junior Member
 
Join Date: Aug 2015
Location: Madrid
Posts: 4
Default HFS-6 wiring for Volvo ME7

Hi all.

I'm trying to install an HFS-6 kit to my 2000 Volvo c70. Is there available any wiring diagram like the one I saw for a Volvo S60 and an hfs-3 kit?

Many thanks.
Reply With Quote
  #2  
Old 05-08-2015, 03:27 PM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,936
Default Re: HFS-6 wiring for Volvo ME7

You can use the same signal pins of the ECM. Green for fuel injector (-) and red for fuel injector(-).
__________________
Richard L
aquamist technical support
Reply With Quote
  #3  
Old 05-08-2015, 03:31 PM
Aleibcas Aleibcas is offline
Junior Member
 
Join Date: Aug 2015
Location: Madrid
Posts: 4
Default Re: HFS-6 wiring for Volvo ME7

Thank you for the fast answer.
Reply With Quote
  #4  
Old 23-06-2017, 07:14 PM
Aleibcas Aleibcas is offline
Junior Member
 
Join Date: Aug 2015
Location: Madrid
Posts: 4
Default Re: HFS-6 wiring for Volvo ME7

Hello again. After two years, finally I decided to install the system.
Having everything in its place, according to the manual, the wiring you told me before and following the first power up instructions from the manual, water doesn't flow thru the flow control module. The flow stops on the inlet stage.
¿Is there any way to check that module or service it? ¿Could be any dirt stuck there, obstructing the valve?

Thank you,

Alex.

Last edited by Aleibcas; 27-06-2017 at 11:53 PM. Reason: Problem solved.
Reply With Quote
  #5  
Old 29-06-2017, 06:35 PM
Aleibcas Aleibcas is offline
Junior Member
 
Join Date: Aug 2015
Location: Madrid
Posts: 4
Default Re: HFS-6 wiring for Volvo ME7

Finally I solved the problem, reading to another guy that had a faulty FCM in the HFS-6 forum. Then, testing the system, no bars got illuminated during the test neither on the road. Instead of that, the B gets lighted when the system is injecting, and with not too much pressure, I presume, since large drops comes from the injector and not a mist.
The yellow led is not lighted, so I suppose that it is not in fail safe mode. Any idea?

I also need to buy a flow restrictor, but they are not in the shop.
It is possible to find the 0,5mm one anywhere?

Thank you,

Alex.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 10:48 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.