#11
|
|||
|
|||
Re: hfs6 problems
rich, it worked! thanks, i grounded that wire coming from the solenoid (it was black), directly to the chassis.
thanks for the help!!! i was not looking forward to buying a new kit. |
#12
|
|||
|
|||
Re: hfs6 problems
Next, pick out the brown wire from the in-coming 8-core cable, cut it from the circuit board. Now connect it to the black wire from the coil (already disconnected from the circuit board)
Let me know.
__________________
Richard L aquamist technical support |
#13
|
|||
|
|||
Re: hfs6 problems
ok, so the brown wire will basically be crimped with the new wire i made? (brown and black from coil connected to one new ground wire).
|
#14
|
|||
|
|||
Re: hfs6 problems
The black ground wire of the FCM is unrelated.
post a picture before I get confused. Mark the wires in question with numbers.
__________________
Richard L aquamist technical support |
#15
|
|||
|
|||
Re: hfs6 problems
here is what I got.
|
#16
|
|||
|
|||
Re: hfs6 problems
Looking at the picture, are you connecting the black wire of the coil permanently to ground?
__________________
Richard L aquamist technical support |
#17
|
|||
|
|||
Re: hfs6 problems
correct. the small black wire coming off the coil is butt connected to a new wire and then grounded to the chassis. is this alright?
I cut the brown wire and left it until further instruction. |
#18
|
|||
|
|||
Re: hfs6 problems
No, you will burn the coil.
Disconect the black wire from ground and connect the end to the short brown wire. from the incoming harness.
__________________
Richard L aquamist technical support |
#19
|
|||
|
|||
Re: hfs6 problems
okie dokie, and that's all i need to do? brown wire from the main harness connected to black wire coming from the coil? and leave the other two ends blank
|
#20
|
|||
|
|||
Re: hfs6 problems
OK, here is an illustration:
__________________
Richard L aquamist technical support |
|
|