#11
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
I think you'd better send the board to Jeff to be repaired. I don't think you will charge you. Just pay the return postage.
He can even test it out at 40% IDC,
__________________
Richard L aquamist technical support |
#12
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
OK. Thanks Richard. I will send it to him. On another note: I used a 5k resistor on the orange wire on the ecu cable. Tephra said to use 5k in his thread, but you had written 220 in your diagram. Do I need to change this? Thanks
|
#13
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
The tephra patch is very flexible. The software can make trimmings to suit any resistor. Send me the link and I will read it and change to 5K if needed.
__________________
Richard L aquamist technical support |
#14
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
|
#15
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
Thank you, I will update it
The 220 ohm was decided some years ago so it is due for an update
__________________
Richard L aquamist technical support |
#16
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
any updates?
__________________
Richard L aquamist technical support |
#17
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
Just received the controller back from Jeff.
Thank you both for troubleshooting the mess I made. What steps do you recommend from here? What settings? Or measure the injector signal again? |
#18
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
I think you should go through the page 14.3 to 14.5 test procedures.
Please let me know.
__________________
Richard L aquamist technical support |
#19
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
Ok, I have to see when I get time to take the bumper off again.
One question: If my cruise and wot voltage were 2 and 1.9 volts before, would they not both be right at 3.0 volts now. How does the controller tell the difference? |
#20
|
|||
|
|||
Re: FIDC too low for HFS-3 V3
I don't think you need to get the bumper off. If you have the engine running, it will probably be OK to spray into the inlet tract for a second or two.
__________________
Richard L aquamist technical support |
|
|