help. where to go

[flyinryanp]

got the whole system hooked up and started going through the checks. the problem is that when i put it in test mode the pump doesnt energize. ive checked power at the relay from both the battery and key, checked ground, fuse is good and in place. all of the light on the controller seem to light up. its as if the controller isnt ground to switch the relay. i put power directly to the pump it works fine.

this test fails
2. Simulating 100% injection test:
Remove the link and put it on the ?TST? slot momentarily
and observe:
- Amber led on the controller board will light up.
- Red led on the controller board also lights up.
- The yellow should light up except for the blue RJ
connector,which lights
- The water pump will start. doesnt start
- There should be full spray on the jet instantly
unless the system is not fully primed. Allow a few
seconds for the water to reach the jet. For longer
hose run installations, remove the jet first to allow
faster priming.
- Remove the link and put it back to the ?PRK?
position before you empty the water tank. If all is
well, move to the next test stage.