#1
|
|||
|
|||
New Install On VL Turbo
I've just bought a hfs-3 kit to install on my RB30 powered VL Turbo. I'm planning on putting the injectors post intercooler. Just wondering where the best position would be. I was thinking in the top side of the 90deg bend coming off the cooler. I've included a pic showing the piping.
Its currently making a shade over 300rwkw through an auto and big converter and using the injector size calculator I've come up with 2 x 1.0mm nozzles. Injectors are 750cc. Does this sound about right for something which should make close to 600 flywheel hp with the w/m kit installed? Last edited by crum86; 29-05-2012 at 04:38 AM. |
#2
|
|||
|
|||
Re: New Install On VL Turbo
That looks like quite the setup. Yes, two 1.0mm jets sounds like a good starting point based on the injectors and the HP level. Putting the jets at the exit of the IC looks to be the best position from the picture.
|
#3
|
|||
|
|||
Re: New Install On VL Turbo
Another quick question. Is there a maximum distance that the FAV can be installed from the actual nozzles?
|
#4
|
|||
|
|||
Re: New Install On VL Turbo
The closer the better. There's no set rule, but it does make a difference.
|
|
|