waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and resources > Aquamist HFS-3 forum

Reply
 
Thread Tools Display Modes
  #11  
Old 02-05-2018, 09:25 AM
trmurphy21 trmurphy21 is offline
Junior Member
 
Join Date: Nov 2017
Location: Dublin
Posts: 15
Default Re: Problems with set up

i'm going to try connecting the black and red wires somewhere else. i'll try the heater fan controls they are on key second position. i'll let you know how i get on
Reply With Quote
  #12  
Old 02-05-2018, 10:36 AM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,773
Default Re: Problems with set up

also check the red and green wire of the grey are not reversed at the fuel injector splice.
__________________
Richard L
aquamist technical support
Reply With Quote
  #13  
Old 02-05-2018, 01:09 PM
trmurphy21 trmurphy21 is offline
Junior Member
 
Join Date: Nov 2017
Location: Dublin
Posts: 15
Default Re: Problems with set up

will do thanks. i have checked these i'll double check again. made the mistake of using a phase tester instead of a multimeter on the green injector wire and engine spluttered a bit (opened injector fully) and getting between 2-4 volts on the blue map sensor (will confirm)

also just to check, what readings should i be getting on the 2 signal points on the pump relay with the sys jumper in and out? meter points: black to earth in boot , red to 2 points or meter points: black to blue , red to red?

cheers
Reply With Quote
  #14  
Old 03-05-2018, 07:23 AM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,773
Default Re: Problems with set up

Can you measure pin16 while blipping the throttle.
__________________
Richard L
aquamist technical support
Reply With Quote
  #15  
Old 08-05-2018, 02:53 PM
trmurphy21 trmurphy21 is offline
Junior Member
 
Join Date: Nov 2017
Location: Dublin
Posts: 15
Default Re: Problems with set up

hi Richard i've been away for a few days i check this later. thanks
Reply With Quote
  #16  
Old 12-05-2018, 03:37 PM
trmurphy21 trmurphy21 is offline
Junior Member
 
Join Date: Nov 2017
Location: Dublin
Posts: 15
Default Re: Problems with set up

Hi Richard I swapped the red wire for the controller as you suggested and it worked!!!! System is priming now putting it back together to take it for a spin make sure everything is OK. The wire I used turned out to be the low fuel light wire and wasn't a steady live
Reply With Quote
  #17  
Old 13-05-2018, 06:03 PM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,773
Default Re: Problems with set up

Thanks for the update.
__________________
Richard L
aquamist technical support
Reply With Quote
Reply

Tags
priming, problem

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 08:59 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.