#1
|
|||
|
|||
Evo IX USDM fail safe (Mac valve) diagram?
I'm trying to figure out how to wire my mac valve for fail safe with a MBC on my evo IX (USDM)
I cant find a diagram, this is my last step so any help would be greatly appreciated. |
#2
|
|||
|
|||
Re: Evo IX USDM fail safe (Mac valve) diagram?
I think this one should work.
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: Evo IX USDM fail safe (Mac valve) diagram?
So I have my Mac valve connected to a constant 12volt source, the same as my boost gauge, wideband etc, Is this correct to have power to it at all times?
|
#4
|
|||
|
|||
Re: Evo IX USDM fail safe (Mac valve) diagram?
It would be much better if you can connect the mac valve to a switched 12V, active only at the "pre-crank" or "run" ignition key position.
__________________
Richard L aquamist technical support |
|
|