#1
|
|||
|
|||
HFS3 V2KC default pcb setting
Hello,
I just got hand on a HFS3 V2KC board which was installed on a Mitsu L200 turbo diesel. This PCB has gone thru few changes. I would like to set it up back to factory setting (it is going on an evo3 now) anyone would have a picture of same PCB with default setting ? Or could you tell me what are the default settings ? I'm pretty sure the MPS soldering has to be removed, then solder bridge IDC again (I think this has been cut) now what about CUST, PWM-, PWM+ Then *1, *1.5, *2 thanks Last edited by zakshaker; 09-06-2017 at 06:10 PM. |
#2
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
factory:
MPS/IDC ........... IDC linked, MPS cut PWM- ........... linked, all others unlinked iDC prescaler .......... x1 linked
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
Thanks Richard.
PWM- is well butchered, that's worry me ! I'll let you know how it goes thanks for your help |
#4
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
That doesn't that bad. As long as the pads are there, you will be OK. Perhaps clear the flux with methanol.
__________________
Richard L aquamist technical support |
#5
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
after closer inspection, the larger pad just when off the PCB just by contact with finger :/
Anything we could do to sort this out ? Last edited by zakshaker; 14-06-2017 at 09:38 AM. |
#6
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
__________________
Richard L aquamist technical support |
#7
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
Thanks Richard I will try that then.
I've tried to send an emails a week ago and an other one tosay. have you changed email address ? |
#8
|
|||
|
|||
Re: HFS3 V2KC default pcb setting
it seems to have done the trick. the led blinks again
Thanks for help as always. I have well received your email, sent two others since then. Doesn't seem to be best way to reach you anymore. cheers |
|
|