waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and new products > Aquamist HFS-6 forum

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #17  
Old 04-07-2018, 02:22 AM
trdhilux trdhilux is offline
Junior Member
 
Join Date: Jun 2015
Location: NSW, Australia
Posts: 16
Default Re: HFS-6 Inconcistent Injection

Another update,

I have pulled apart the pump, haven't found any signs of corrosion in the pump, bearings etc look fine, spins freely by hand. The diaphragm looked really clean as well.

I am not sure of the anti surge unit on the outlet of the pump, whether it could have blockages etc. Is this unit necessary, i notice the later pumps don't have it.
Looks like ill need to wire in a pressure gauge and see what pressure is coming from the pump.

Is there a way to test the hall affect sensor on the printed circuit board?

Is there a minimum flow that the sensor will only work on. I presume that if i get 260cc a minute, that the sensor should read this, as with a smaller jet installed 260cc/min is achievable.

What pin on the gauge is the flow sensor trigger?

Regards
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 04:02 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.