New install issues

[rallyfreak202]

Richard,

I’m glad this forum exists. I did some searching and couldn’t find my exact problem although it could be from a clogged line. Please weigh in on your thoughts.

Purchased new late 2017. Installed in 1995 Audi S6. 5cyl turbo. 630cc DEKA high impedance injectors.

Problem 1: “B” on gauge illuminates and then water level sensor illuminates. No flow shown in this condition. I can hear controller click and unclick when condition goes away. I noticed this when I tweaked the SC.

Problem 2: very little flow. Before fault listed above and SC tweaking, I only saw flow at WOT and even then it’s not full flow. Only brief flow. This was right after install but now I have another problem. I adjusted the THRES, GAIN, and FS-DL with hopes of getting more flow from the system at earlier onset. No luck. I believe we should solve this problem after solving the first.


What I’ve done: green IDC illuminates while running, SYS jumped with PRK to see manual flow post FAV (flows well but engine must be on to see flow), and banged my head out of confusion.