HFS-3v2 wiring diagram Mazdaspeed 3

[2.0t03speed]

Hey i have a quick question about wiring up a v2 on my mazdaspeed 3. i have the diagram for the v1, but i need to know what to do with the extra di specific wire on the v2.

v1 diagram for the ms3:



v2 generic diagram:



Thanks

[Richard L]

I will make a drawing for the v2. It is different to the V1.

[2.0t03speed]

Thanks!!!! Also just fyi i have a gen 1 ms3

[Richard L]

Just uploaded this one (gen1)... Let me know if it works with the v2 board. If you have the serial number, I can check.

http://www.aquamist.co.uk/vbulletin/...2407#post12407

Richard

[2.0t03speed]

the only problem i have with that is i think it's for the hfs-3v3. i don't have the user harnes for the idc sense and i don't see it mentioned anywhere in my user manual either. Now if i look at the hfs-3v3 w/ the red control board that would make sense as it has the idc sense user harness brought down from the hsf-4. the harness i have is just the the v1 hfs-3 only it has an extra yellow wire for di injector input.

i'll get the serial number for the box later tonight

[Richard L]

I will post it up. I did it just in case you might have a v3 board.

[Richard L]

If you have black circuit board (v2) without a green harness, it must be an earlier version. The DI decoder was still under development. You can return the circuit board to me for an upgrade to a later version of the v2.

[2.0t03speed]

Yep thats what i have black circuit board without the green user harness. i'm going to get the serial number tonight just so you can confirm everything.

[Richard L]

The earlier version of the HFS3v2 is on beta test for the first few hundred or so. The green harness were supplied on request basis, help us keeping track on the progress on the DI specific applications. I believe 90% of the DI car had good results. The MS3 was a tricky one to solve at the time. Did you buy the your HFS3v2 from new specifically for the MS3?

[2.0t03speed]

No i purchased the kit used.