waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and new products > Aquamist HFS-3 forum > HFS-3 wiring diagram to a specific model of car

Reply
 
Thread Tools Display Modes
  #1  
Old 27-07-2012, 10:03 PM
The Alchemist The Alchemist is offline
Junior Member
 
Join Date: Mar 2012
Location: Doylestown, PA
Posts: 9
Default Am I the first to put it on an LS1 (F-body or Corvette)

I have a question about the injector signal wires. I'm running an LS1 that is in a 2000 Firebird Trans AM (LS1 motor) and I found the signal wire for the injectors, but no the ground. I'm guessing it's a common ground for each injector. I was planning on tapping the signal right at the pcm, but I can't find an injector specific ground.

Here's a list of the pinouts on our pcm's:
http://www.lt1swap.com/2001_PCM_CONN_PINOUT.htm

As you can see, I plan to use the pinout for the #1 injector, which is positon #36, but there is no #1 ground.

Has anyone installed this on an LS1 before?
Reply With Quote
  #2  
Old 27-07-2012, 11:00 PM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,936
Default Re: Am I the first to put it on an LS1 (F-body or Corvette)

Most PCM switches the injector to ground to open it. Injectors are all connected to common 12V.
__________________
Richard L
aquamist technical support
Reply With Quote
  #3  
Old 28-07-2012, 12:55 AM
Howerton Engineering
Guest
 
Posts: n/a
Default Re: Am I the first to put it on an LS1 (F-body or Corvette)

Green wire of the grey harness would go to pin 36, you could connect the red wire of the grey harness (12V system ON signal ) to pin 57 if it is switched (pre-crank) power.

There might me a better one for the red wire, but that would probably work.
Reply With Quote
  #4  
Old 27-11-2016, 08:13 PM
zoom07 zoom07 is offline
Junior Member
 
Join Date: Jul 2016
Location: Bakersfield
Posts: 5
Default Re: Am I the first to put it on an LS1 (F-body or Corvette)

so it appears this is along the same lines for me for a L76 (ls3ish) style pontiac g8 gt
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 09:13 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.