waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and resources > Aquamist HFS-3 forum > HFS-3 wiring diagram to a specific model of car

Reply
 
Thread Tools Display Modes
  #1  
Old 27-11-2016, 06:50 AM
zoom07 zoom07 is offline
Junior Member
 
Join Date: Jul 2016
Location: Bakersfield
Posts: 5
Default Pontiac G8 GT

I'm curious on how i'm suppose to wire up my ECU connector for my HFS-3 module which is these instruction in the manual

2. Signal to the grey RJ48 connector:
- Red ................. Ignition switched 12V
- Green ............. Fuel injector (-) pin
- Blue ..................MAP sensor (optional)

attached is what i believe the ECM wiring pinout but each fuel injector has its own return (-) . so are are these internally connected so i can hook it to any injector fuel control wire ?

I do see my MAP sensor Signal wire is Pin 58 so all i do is run that wire into my ecm on that pin???
just trying to figure this all out and cut cost on my installer trying to charge me an arm and a leg to do this.

ECM DATA
http://www.grrrr8.net/crazypaul/2008GTPinouts.pdf
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 10:55 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.