waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and new products > Aquamist HFS-6 forum

Reply
 
Thread Tools Display Modes
  #1  
Old 17-06-2015, 10:05 PM
stock400whp stock400whp is offline
Junior Member
 
Join Date: Jun 2015
Location: california
Posts: 1
Default hfs6 affected idle?

I purchased a used unit and proceeded to install using this instruction.

http://www.aquamist.co.uk/HFS6/HFS-6-4w.pdf

new lines were used and i was able to do a manual test.
aside from the flow control Ethernet plug being a little loose the system sprays.


however once i start it, it affects the idle tune of the car. it starts stumbling and a quick rev would make the car die.

unplugging the ecu plug from the hsf6 unit and the car runs normal again.


here is the ecu pinout for my 1998 transam
http://www.lt1swap.com/1998_ls1_pcm_pinouts.htm

from the aquamist i needed to connect the following.
I used the following.

IGNITION SW. (INJECTOR +)
Blue connector pin 19

FUEL INJECTOR (-)
red connector pin 33

MAP SENSOR (0-5V)
BLUE connector (pin 48)


The only thing I can think of is the fuel injector - is connected wrong. I noticed what looks like a black smoke like its turning on the injectors?

anyone have a suggestion on which connector to tap into.

thank you
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 08:50 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.