waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and resources > Aquamist HFS-3 forum

Reply
 
Thread Tools Display Modes
  #1  
Old 31-07-2022, 11:17 AM
Bradswims11 Bradswims11 is offline
Junior Member
 
Join Date: Jun 2022
Location: Auckland, New Zealand
Posts: 1
Default Hfs-3.1 soldering

Hi everyone,

I've been looking at the version 3.12 instructions about soldering the mps pad onto the idc pad to allow for 30% boost correction for flow, but I have the earlier model red v3.1 circuit board, S/N 102859. Are these instructions still applicable for this board? Once soldered, do you then need to use a spare jumper to have both the idc and mps settings selected, or is just one fine as they're tied together?

I was looking for advice on the initial setup also. The car is a Mitsubishi, running a 4g63t motor with 9.6:1 comp, turbo is equivalent to a gtx3576r, running over 25pai. The plan was to run 4x0.5mm direct port nozzles, with a 0.5mm pre throttle body and a 0.8-1.0mm nozzle in the turbo volute to try and boost the turbos efficiency. I have 1000cc fuel injectors and the plan was to start wmi at 20% idc as that's around 1 bar of boost. Should I move the pre-scaler or will I have enough adjustment where it sits? Currently the car is only hitting 70% idc max.
Reply With Quote
Reply

Tags
mitsubishi, setup, solder

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 10:17 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.