Injecting prior to turbo comp' impellers

[mr2turbored]

i to am seriously thinking about doing this after a good read. my only issue is that i'm using a tiny turbo and very short air intake

the compressor intake is only 48mm so fitting a jet right infront will obstruct most of the air intake. Right before the compressor there is a 90 degree bend at 48mm diameter which the outside is to close to the oil filter to fit the jet there pointing at the compressor. But after that bend its 12" of straight 2.5" diameter pipe with the air fitler at the end. My idea was to fit the jet into the end of the air filter pointing straight down that longish intake.

Would that be ok?

also with using the pre turbo setup, i would still like to run a normal setup pre TB, would i be able to just run a T section off the pump to power 2 jets or do i have to run a twin pump configuration? I'm using the Aquamist 2D system and would like if possible to run 50/50 meth/water

Any issues do you think?

thanks