|
#1
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Quote:
Quote:
PS the system can inject based on 100%-IDC, 100%-MPS or 70/30. Quote:
I do get feedback from PWM-V converted users. Mainly the system more linear and does not bog the engine on low rpm and does not run-on during gear change. This confirms the theory is sound. More readings below: http://forums.nasioc.com/forums/show....php?t=1413320 (a few PPS WMI makers has responded) Those claimed pressures are what the pump is capable of when dead headed. You would only have found that out after the purchase; The by-pass valve is actually set to between around 200-220 dead-headed. What else is there for a PPS system to shout about? You can increase the pressure on the on the aquamist pump to beyond 250 psi by adjusting the set screw on the front of the pump if you wish. The pump will heat up quite quickly. Two water tanks of the same capacity, one 30 feet tall and the other 18 feet. Open up the same drain tap on both, the water level of the 30 feet tank will drop faster.
__________________
Richard L aquamist technical support |
#2
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Thanks Jeff and Richard, I really appreciate all the info. It will take me a little while to traverse all the info in that NASIOC link!
I really look forward to running this kit. |
#3
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
For some unknown reason, aquamist is not well represented on the american v8 scenes. Most probably lack of magazine hypes. Another factor has to do with price. It costs less to make a PPS system with just an slow acting valve (off the shelf type).
You could probably tell me more.
__________________
Richard L aquamist technical support |
#4
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Hi,
Could you confirm my nozzle choice please? 4 x 1000cc F-injectors -> 4000cc (running ~65 F-IDC) 15% water -> 600cc 20psi boost -> 140psi pump pressure chart I think 2 x 0.7mm (M3.9) nozzle is what I would need. Am I right? Thank you! |
#5
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Please allow 10% system loss and some ceiling in case you need more.
Go for 2x 0.8mm instead.
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
Hello,
What will be the best dual nozzle location on post-intercooler pipe? 1 or 2? Regards. |
#7
|
|||
|
|||
Re: Aquamist HFS-3 system for 2010 ..... "Q and A"
The "2" is better, 3-6" apart.
__________________
Richard L aquamist technical support |
|
|