waterinjection.info  

Go Back   waterinjection.info > Aquamist specific system Q and A and resources > Aquamist HFS-3 forum

Reply
 
Thread Tools Display Modes
  #1  
Old 03-08-2018, 10:13 PM
Wehooper4 Wehooper4 is offline
Junior Member
 
Join Date: Jul 2018
Location: Chattanooga, TN
Posts: 1
Default HFS-3 Controller Blowing Fuse - Fixed

Fixed this before Richard could get back to me, but I'm posting this incase anyone else has this issue in the future.

Upon installing my HFS-3, it blows the 5A wire protection fuse every time I went through the Power Up Procedure as outlined in the manual. Tested all of the wiring and there were no shorts.

I probed the HFS-3 controller board to try and locate the fault: There was a dead short between 12V+ and "power" ground. This short cleared if you remove the onboard fuse.

Tracing the board with a meeter, I discovered the only things connected to "power" ground are the FAV and Pump control mosfets, board power relay, and a diode with the marking "S1J". This cross references to a Vishay rectifier diode with a 1A continuous 40A burst current rating, and it appears to protect the rest of the board from a reverse polarity and power relay coil flyback.



This diode was the only thing that was across both 12V+ and “power” ground, so I unsoldered it to see if that was the issue.



No more short! The only DO-214AC diode Could get on short notice was a Farchild ES1G, one tier down in specs but probably close enough.



Plugged it in and followed the Power Up Procedure once again, and everything works!



This was LIKLEY caused by polarity being reversed at some point while installing it .
Reply With Quote
  #2  
Old 07-08-2018, 08:52 AM
Richard L Richard L is offline
Manufacturer sponsor
 
Join Date: Oct 2003
Location: England
Posts: 4,785
Default Re: HFS-3 Controller Blowing Fuse - Fixed

good work!
__________________
Richard L
aquamist technical support
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 06:33 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.