HFS-6 and Low-impedence injectors??

[Chris_M]

Richard,

I need some help. I finally got my new HSF-6 installed and it won't pass the initial power-up procedure. All goes well right up to step 3, with the key in position 2 the gauge behaves as expected but then all the light on the board come on and the system sprays at 100% constantly. I found that if I disconnect the injector (-) then it stops, however then I have no IDC signal. Does this have something to do with the fact that I am running low-impedence injectors? Is there a fix? I don't have the option to use high-z injectors because of their size.

Thanks.

Chris