#1
|
|||
|
|||
System 2d install instructions
Hello
I just got System 2D, used , taken out from crashed car. It seems to be complete , but i dont have any instructions for it of course. Where can i find them? thanks! hIGGI |
#2
|
|||
|
|||
The 2d is supplied with one sheet of wiring instruction. Can you tell me the serial number at the bottom of the the pump. I will try find a suitable wiring diagram fior you
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
9917827
thanks |
#4
|
|||
|
|||
i have found some diagrams online, but i those do not tell anything about adjustment of pressure switches for example....
|
#5
|
|||
|
|||
There are two pressure switches:
1) 806-157 (3-30psi) for system activation relative to manifold pressure Default = 10psi 2) 806-162 (2-10 bar) for system pressure (water). Default = 7 bar
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
Ok, and how do you set them up when you dont know what values are set at?
|
#7
|
|||
|
|||
You cannot do it unless you have a pressure gauge. Everything is preset from the factory. But it is a used kit, chances are, they have been alterered.
__________________
Richard L aquamist technical support |
#8
|
|||
|
|||
Yes, i belive it has been altered and i was hoping there is some guide like "one turn left from fully closed or something like that...."
I guess i will have to use gauge and make some kind of bench to set it up. One question to wiring : How do you wire it up on staged injection car? To primary injectors, or to secondary injectors which turn on only at boost and only above 3800 rpm? |
|
|