#1
|
|||
|
|||
Nozzle spray angle...
I am looking at possible injector locations and would like to set the nozzles
so that there is no projection into the airflow, and have the tip of the nozzle recessed 2-3 mm as per this drawing... So if someone can advise me the injector spray cone included angle, I can look at how this setup can be achieved on 1.6-2.0 mm wall alloy tube. Also, I have seen some data that suggests recessing the tip promotes better vapourisation, and I would appreciate any input indicating that this is a worthwhile exercise. Cheers... jondee86 PS: I do recall seeing a post that mentioned the cone angle was 80 deg, but I have been unable to locate that again. |
|
|