#1
|
|||
|
|||
HFS-3 in EVO VI
Just added water and all this popped out
after understanding what everything is and does i came across this problem, the tank outlet was already in place and the pump inlet didnt agree with it. so i bought 6mm push in fittings to do this. Last edited by taiman; 06-05-2010 at 12:43 AM. |
#2
|
|||
|
|||
Re: HFS-3 in EVO VI
drilling of injection points, just before the throttle body
loctite ing in place lower coldside piping picture Last edited by taiman; 09-05-2010 at 06:19 AM. |
#3
|
|||
|
|||
Re: HFS-3 in EVO VI
from the boot to the outside
from the back to the front FAV mounting, underneath the engine bay chassis rail covering everything with split tube cable protectors to be continued... |
#4
|
|||
|
|||
Re: HFS-3 in EVO VI
used velcro to make it stay
now just to mount the tank and tune |
#5
|
|||
|
|||
Re: HFS-3 in EVO VI
This install is well thought out. I didn't want to post earlier until you have finished. Congrets.
One the tank install, is there room for the level sensor? Please test run the system before tuning.
__________________
Richard L aquamist technical support |
#6
|
|||
|
|||
Re: HFS-3 in EVO VI
Quote:
if you have a closer look at the tank pictures, the level sensor is in place at the back end of the pump. came pre-drilled and installed by Howerton Eng. just waiting on anti-slosh foam now for further piece of mind. |
|
|