FAV not working from controller

[boostsys]

I can do this tomorrow.

[boostsys]

Resistance between red and black pins - 0 Ohm.

[Richard L]

This with the FAV plugged in?

[boostsys]

Originally Posted by Richard L

This with the FAV plugged in?

Yes, FAV plugged in

[Richard L]

0 ohm is a short circuit. The FAV should have a resistance of 12 ohms. What resistance scale were you on?

Send a picture of the reading.

[boostsys]

Originally Posted by Richard L

0 ohm is a short circuit. The FAV should have a resistance of 12 ohms. What resistance scale were you on?

Send a picture of the reading.

Oh, sorry. There is no resistance between red and black pins.

[Richard L]

OK.

Measure the resistance between black and blue

Also can you check the inside of the FAV connector. I there must be a loose joint inside.

[boostsys]

Inside of the FAV connector red and yellow, black and blue wires soldered together

[Richard L]

Are they soldered onto the the two connector's contacts securely?

[boostsys]

I will have checked it tomorrow.
Maybe red wire have a problem, because between yellow and black (blue) resistance 13.5 Ohms.