#1
|
|||
|
|||
Water/Meth Flow vs. Water Flow Efficiency
Initially I was spraying water.
After calculating the flow rate that I needed, I would actually measure the amount of flow through the nozzle by: (1) using a pressure regulator to apply the same pressure to the controller that I would be running. (2) have the nozzle flow into an 1 gallon bottle for 1 minute. (3) measure the collected water. (4) then add in a little more flow because the nozzle was not under boost pressure when tested thus would flow a little more than when actually used. When I went to water/meth a few months ago, I tested my new flow rate with water again. I increased my boost pressure and decide to clean the jets and retest. First at the old boost level. This time the test was done with 50/50 instead of water. To my surprise, the flow rate was noticeably higher than before. Either: (1) my system was flowing more because it is now broken in. (2) water meth flows easier/more than water due to less density. (3) or operator(me) error. Has anyone notice this? |
|
|