#11
|
|||
|
|||
Re: Water/Meth Tank options
I need to make a pressure vessel for my project and I was thinking of alloy,but couldn't the inside of the tank be coated with Por15 tank liner?
|
#12
|
|||
|
|||
Re: Water/Meth Tank options
Sorry for bumping up an old thread but with meth and alloys is this the same for alloy tube/pipe and alloy fittings like dash/an fittings on tanks?
is it only meth that does this or even a water/meth mix? |
#13
|
|||
|
|||
Re: Water/Meth Tank options
Fuel/AN fittings etc are all hard anodized which offers them protection.
Whether it is 100% protection I'm not sure, but it is a lot more than bare alloy. The less methanol there is, the less it will attack. Although I dont think it's that bad anyway if you're concerned, get some of the alloy and leave it in some methanol and see how it copes. |
|
|