#51
|
|||
|
|||
Re: Mazdaspeed 3
Hi Richard L, when you have a chance can you comment?
|
#52
|
|||
|
|||
Re: Mazdaspeed 3
Quote:
__________________
Richard L aquamist technical support |
#53
|
|||
|
|||
Re: Mazdaspeed 3
Quote:
Oh and just to verify my thinking is correct, by soldering the W for the AUX INPUT FAILSAFE, the control will trigger a fail-safe alarm if the methanol/water mixture in the tank goes below the tank level sensor? Thanks again for the help! |
#54
|
|||
|
|||
Re: Mazdaspeed 3
Thank you.
You can do either one of the following or both: W = water level led turns on gauge F = wastegate cut
__________________
Richard L aquamist technical support |
#55
|
|||
|
|||
Re: Mazdaspeed 3
I think I'm confusing myself here. The AUX INPUT FAILSAFE is if I'm connecting a 3rd party signal to activate the onboard failsafe relay. I'm not using a 3rd party signal so I can keep this as the default setting.
I was under the impression that soldering the W setting would allow the water level sensor to cause a failsafe. Sorry for the mixup. One last question for you, is there an indicator on the gauge if the control loses power? Reason I ask is I will be using the MAP Switching Channel for the fail-safe and not the Change-Over relay. Last edited by Puddin15; 20-08-2016 at 08:38 PM. |
#56
|
|||
|
|||
Re: Mazdaspeed 3
If there is a power failure the Map switch channel will not work. The only channel that will work under this circumstance is the failsafe relay output. Brown white and black wires from the grey harness.
__________________
Richard L aquamist technical support |
#57
|
|||
|
|||
Re: Mazdaspeed 3
Thanks Richard.
|
#58
|
|||
|
|||
Re: Mazdaspeed 3
Richard,
Another question for you. In the wiring diagram you have for the 2008 Mazdaspeed 3, you have pin 1AY listed as the Fuel Injector Relay. It looks like pin 1AY is listed as "+12V from ignition switch, PJB F69, 20A" in the factory connector pinout diagram I have. Also, for #1 Fuel Injector Coil + you have pin 2BG listed which according to the factory connector pinout diagram is "Fuel Injector #1 & #4 Common". Finally you have #1 Fuel Injector Coil - listed as pin 2BB which is "Fuel Injector #1" according to the factory connector diagram pinout. Can you verify the diagram you have on page 1 is correct? |
#59
|
|||
|
|||
Re: Mazdaspeed 3
Is there a problem with the following: ???
AFAIK, it is correct 1AY as a switched 12V source? (2BE will also work) Injector common is 2BG Injector common is 2BA
__________________
Richard L aquamist technical support |
#60
|
|||
|
|||
Re: Mazdaspeed 3
Here is the latest update for the gen2 MZ3 :
__________________
Richard L aquamist technical support |
|
|