Adding a mappable controller...

[nutron]

Firstly YAY, the forum works again!

Secondly, I may have used alot more water than expected because I had the intercooler sprayers connected and they flow independently of the MF2's control. Secondly the slower solenoid I have may not have been able to pulse fast enough for the Fuel injection 60Hz setting, simply being on or off (as Richard suggested). To rectify this, I have removed the jumper and it is now running at 30Hz. I tried it out with a nozzel into open air and it does seem much more responsive.

During a stint where I had no methanol, I was running pure water and despite the scientific research I have read on water injection, it did seem to reduce smoke through out the range compared to a water methanol mix.