waterinjection.info  

Go Back   waterinjection.info > Injection Applications (making it work) > Gasoline Forced-Induction

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #21  
Old 19-06-2018, 10:15 AM
rotrex rotrex is offline
Senior Member
 
Join Date: Jan 2014
Location: Germany
Posts: 187
Default Re: Nozzle size

I would have tried to centre them as much as possible in line with the fuel injector. Alternativeley consider adding a second set of jets on the opposite site of the fuel injector.
But I see your reasoning as a compromise had to be made due to space constriction and the curvation of the runners prohibiting going back much further.

Spraying like this will IMHO likely lead to less than ideal in cylinder distribution. Most spray will pass through one inlet valve only at least during the time the valve is open. Some spray will accumulate in the port while the inlet valves are closed. But there is reason the fuel injector sits in the middle, equal distribution.


I am looking forward to reading about how it performs. If you’re not happy with the knock supression, you can always add a second set on the other side and get a more ideal distribution.
Jet size might have to be adjusted, of course. Or boost increased.... :-)


PS. If the plenum is still off, you could prep for this two sided install by installing just the threaded bungs and plug them. This would safe the effort of having to remove the inlet again in case you would need the second set.

Last edited by rotrex; 19-06-2018 at 10:19 AM.
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT +1. The time now is 10:34 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.