|
#1
|
|||
|
|||
CUSTOM AQUAMIST GAUGE?
Hey,
I currently own an E92 M3 with an ESS vt2-625 supercharger kit and I am looking to purchase the aquamist hfs-3 kit to aid in IAT suppression. I am curious if the bezel on the gauge could be customized? Here is my current gauge setup: I am looking to take the leftmost gauge out and replace it with the aquamist controller. I think the bezel around the aquamist gauge would ruin the appearance of my setup, so I was wondering if there was way the bezel around the aquamist gauge could be removed? Or could I have it customized to be 1/2 its original thickness? Or essentially altered in any other way in order to make it go with the look of my current setup. Thank you very much! |
#2
|
|||
|
|||
Re: CUSTOM AQUAMIST GAUGE?
what is the outside diameter of the gauge bezel?
__________________
Richard L aquamist technical support |
#3
|
|||
|
|||
Re: CUSTOM AQUAMIST GAUGE?
I know that online it says the gauge is 52mm, I am not sure the diameter of it (and by thickness i mean if your looking at the gauge from its profile, not directly head-on - a better word would probably be the "depth," meaning im looking to have the gauge relatively on the surfact of the pod, and not look deeply recessed into the bezel)
|
#4
|
|||
|
|||
Re: CUSTOM AQUAMIST GAUGE?
The transparent front protrudes further than the aquamist but the gauge face is recessed more than the aquamist gauge face.
This is the nearest match Howerton offers: http://howertonengineering.com/wp-co...uge-bezels.jpg Can the deleted gauge bezel be separated from the body? Might just use the bezel for the aquamist gauge.
__________________
Richard L aquamist technical support |
|
|